How to use the Galletto 1260 ECU tuning cable to read/write BMW MS43/MS42?
How to use the Galletto 1260 ECU tuning cable to read/write BMW MS43/MS42?
Follow the procedure bellow, you can use the Galletto 1260 ECU tuning cable (Chinese clone is ok) to do the BMW MS43/MS42.
Read and write BMW E46 MS43 ECU for Euro 2 software:
Get a Galletto 1260 cable with the extra adapter
Here is a close-up of the 2 connectors. The white 2 pin connector has "L" and "K" pin identifiers and the black 2 pin connector, "+" and "-" which should be power and ground.
How to use the Galletto v1260 ECU flasher to read/write full flash from MS43/MS42?
1. First, you need to remove ECU from car.
2. Turn off 4 torx bolts from case and extract mainboad.
3. Locate 104 boot pin
4.Short boot pin to GND
5.Put "+12V" and "-" to your black (2 pins) socket connected to Galletto cable.
6.Connect K-line from white (2pins) socket to ECU.
7.Connect power to ECU
Note: If you use the K-line pin.
1) L-line no need
2) 12V and GND is direct power source to black (2pin) and to ECU (4/7 and 26)
After 6 Seconds (from power connected) remove wire between 104pin and GND. That's all. ECU now in bootmode and you can "connect".
Test result:
Successfully read and write MS42/MS43 full flash in bootmode with Galletto v1260 and JMGerageFlasher software.
Follow the procedure bellow, you can use the Galletto 1260 ECU tuning cable (Chinese clone is ok) to do the BMW MS43/MS42.
Read and write BMW E46 MS43 ECU for Euro 2 software:
Get a Galletto 1260 cable with the extra adapter
Here is a close-up of the 2 connectors. The white 2 pin connector has "L" and "K" pin identifiers and the black 2 pin connector, "+" and "-" which should be power and ground.
How to use the Galletto v1260 ECU flasher to read/write full flash from MS43/MS42?
1. First, you need to remove ECU from car.
2. Turn off 4 torx bolts from case and extract mainboad.
3. Locate 104 boot pin
4.Short boot pin to GND
5.Put "+12V" and "-" to your black (2 pins) socket connected to Galletto cable.
6.Connect K-line from white (2pins) socket to ECU.
7.Connect power to ECU
Note: If you use the K-line pin.
1) L-line no need
2) 12V and GND is direct power source to black (2pin) and to ECU (4/7 and 26)
After 6 Seconds (from power connected) remove wire between 104pin and GND. That's all. ECU now in bootmode and you can "connect".
Test result:
Successfully read and write MS42/MS43 full flash in bootmode with Galletto v1260 and JMGerageFlasher software.
How to use the Galletto 1260 ECU tuning cable to read/write BMW MS43/MS42?
Reviewed by Unknown
on
01:37:00
Rating:
Reviewed by Unknown
on
01:37:00
Rating:
Aucun commentaire: